English 
T: +86-15817577177
E: Aimee@Topfive-Cable.Com
E: Aimee@Topfive-Cable.Com
No.1 Industrial Park, Tang Lian Road, Tangxia Town, Dongguan City, China.
Views: 220 Author: Site Editor Publish Time: 2024-03-06 Origin: Site
Grounding: The burning law of the electronic wire beam is that in the circuit of the power supply system, the electronic wire beam will burn no matter where it is grounded. The connection of the intact part after the combustion can be used to ground the wire there. If the electronic wiring harness burns out to the wiring part of the electrical equipment, the malfunction of the electrical equipment will be marked.
Short circuit: The electronic wire harness is kneaded and impacted by the outside world, causing the insulation layer of the wires in the electronic wire harness to be damaged, resulting in a short circuit between the wires, causing some electrical equipment to lose control, and the fuse to blow.
When judging, the electronic wire harness connectors and control switches at both ends of the electrical equipment can be disassembled, and the short circuit of the circuit can be detected by the electric meter or the test lamp.
Open circuit: In addition to the obvious cracking phenomenon, most of the rare faults occur between the wire and the wire terminal. After some wires are cut, the outer insulation and wire terminals are intact, but the inner core wire and wire terminals have been cut.
In the judgment, a tensile test may be performed on the heat-resistant conductor and the conductor terminal suspected of being open. In the tensile test, if the conductor insulation layer gradually becomes thinner, the conductor can be regarded as an open circuit. Poor line contact and faults often occur in connectors.
Poor connector contact: When a fault occurs, electrical equipment cannot operate normally.
Topfve cable was established in 2010 years.Our products are widely used in electrical products, industrial display screen, Medical display, UAV unmanned aerial vehicle and so on.
